FUEL LEVEL SENDER, 0-90 OHM

OBS 2 versioner existerar. 

Det första gäller den äldre modellen. 

 

Version 1 Older type: 

 

Click here to download installation instructions (PDF)

Float-style fuel level sending units with standard SAE 5-bolt mounting pattern. Easy to install using the supplied hardware and Deutsch connectors (gauge not included). Fits most fuel cells including Radium, ATL, Fuel Safe, Pyrotect, Harmon, Jaz, etc. and extensively used with the Radium Fuel Cell Surge Tank. Unlike most other senders, this rugged design features a FR4 conformal-coated PCB, epoxy potted electrical terminals, and an anodized surface finish making it suitable for use with gasoline, diesel, and specifically alcohol based fuels including methanol, ethanol, E85, etc.
Made here in Portland, USA.

---

NOTES:
-All level senders are 0 ohms empty to 90 ohms full. This 0-90 ohm range is common with many OEM gauges.
-Radium does not sell fuel level gauges, but a popular option is this Autometer Fuel Level Gauge
-To test the sender, measure the resistance between the two wires while tipping the sender to allow the float to move.
-Fuel level senders carry a 1 year warranty through Radium Engineering
-If purchased with a Radium Fuel Cell Surge Tank (FCST), the sender will come pre-installed.
-Not compatible with MS109E fuel.

ALWAYS MEASURE THE INSIDE DEPTH OF THE FUEL CELL BEFORE SELECTING SENDER LENGTH.

If using the Radium Spare Tire Fuel Cell, select the 8" long sender.

---

Electrical:
12VDC with unit connected to a single electric receiver gauge that utilizes an AC resistance curve (shown below).

---

Mounting:
When mounted properly, the gasket seal will withstand an internal tank pressure of over 6psi conforming to SAE J1810.
 
Includes:
-Level Sensing Probe
-SAE 5-Bolt Gasket
-Stainless Bolts 10-32 (x5)
-Nylon Sealing Washers (x5)
-Deutsch DT 2P Connector
-Deutsch DT Sockets (x2)

---

Version 2 New type:

Click here to download installation instructions (PDF)

This fuel level sensor uses the standard SAE 5-bolt mounting pattern, extensively used with the Radium Fuel Cell Surge Tank.

Full stainless steel sealed construction with magnetic float.
Resistance: 0 ohm empty, 90 ohm full

Suitable for use with gasoline, diesel, water, and all alcohol based fuels including methanol, ethanol, E85, etc.

The fuel level sender is easy to install using the supplied hardware and Deutsch connectors (gauge not included).
NOTES:
-All level senders are 0 ohms empty to 90 ohms full (common with many OEM gauges.)
-Radium does not sell fuel level gauges, but a popular option is this Autometer Fuel Level Gauge
-To test the sender, measure the resistance between the two wires while tipping the sender to allow the float to move.
-If purchased with a Radium Fuel Cell Surge Tank (FCST), the sender will come pre-installed.

Each level sender includes the following:
-Level Sensing Probe
-SAE 5-Bolt Gasket
-Stainless Bolts 10-32 (x5)
-Deutsch DT 2P Connector
-Deutsch DT Sockets (x2)

SPECIFICATIONS:
PROBE MATERIAL: 304 Stainless Steel
FLOAT MATERIAL: Plastic Buna-N
MOUNTING FLANGE: 5-Bolt SAE
MOUNTING GASKET: FKM Viton
RESISTANCE: 0 (Empty)-90 (Full) Ohms
PVC WIRES: 18" (460mm) with PA Cover
CONNECTORS: Deutsch DT, 2P